Dell EMC Server Administrator Storage Management 9.1.2

Support for BOSS-S1 RAID Controllers

The BOSS-S1 RAID Controllers supports the following enumeration and monitoring operations:
  • The physical disks are (M.2 devices) are directly connected to the Controller
  • Enumeration of Physical Disks (M.2 devices) are supported
  • Enumeration of Virtual Disks on M.2 devices are supported
The following tasks are not supported:
  • Configuration options are not supported for this controller.
  • Enclosures and connectors are not applicable for the Controller.
  • No physical disks operations / tasks are supported for this Controller
  • No configuration operations are supported for virtual disks including creation, deletion, reconfiguration and so on.
  • No controller tasks are supported
The following physical disks properties are enumerated for this controllers: ID, Status, Name, State, Bus Protocol, Media, Revision, Model Number, Capacity, Used RAID Disk Space, Available RAID Disk Space, Hot Spare, Vendor ID, Product ID, Serial No., Negotiated Speed, Capable Speed, Sector Size and SAS Address.
NOTE: SAS Address is not available for M.2 devices.
The following controller properties are enumerated for this controllers: ID, Status, Name, Slot ID, State, Firmware Version, and Patrol Read Rate.
NOTE: Even though the Rebuild Rate is displayed in the OM GUI and CLI, please do not consider the same. This property will not be enumerated.
The following virtual disk properties are enumerated for this controllers: Status, Name, State, Tasks, Layout, size, Device Name, Bus Protocol, Media, Read Policy, Write Policy, Stripe Element Size, and Disk Cache Policy.
NOTE: Layout option will not be available for non-RAID disks.
NOTE: For BOSS-S1 RAID Controller, the physical disk is directly connected to the controller as no enclosure or connector is applicable for this controller.
NOTE: Any configuration operations through OMSA are not supported for virtual disks, physical disks and controllers.