xchar, version 0.2 Copyright (C) 2006-2007 Brian Keck. All rights reserved. This module is free software; you can redistribute and/or modify it under the same terms as Perl itself. For a description of xchar see firstly xchar.pod in this directory (xchar-0.2), which becomes xchar(1) after installation. Prerequisites are Tk and X11::Protocol. Install in the usual way: perl Makefile.PL make sudo make install The 'make test' is useless currently. If you suspect that you might not like xchar, & like to keep your system spotless, you might want to save the output of make uninstall which does nothing but output a list of files to delete. If you're impatient a quick way to start is: mk.xtb > ~/.xtb mk.xscreens > ~/.xscreens At this point you should be able to run xtb from the command line, and raise & move windows via xup & xmv. Getting keyboard mappings to do this (without which there's no point to xchar) is sadly still a bit of work, and depends on your window manager. If you happen to be using fvwm, you can do most of the work with: mk.xchar fvwm >> $FVWMRC where FVWMRC is ~/.fvwm/config or ~/.fvwmrc. However, these fvwm key mappings assume that mod3 (xup) & mod4 (xmv) are not used for something else, and have had keys assigned to them. I do this in my .xinitrc file. On my Sony TX laptop I use respectively the key with the picture of a menu and the key with the mswin logo: xmodmap \ -e 'keycode 115 = Super_L' \ -e 'keycode 117 = Super_R' \ -e 'add mod4 = Super_L' \ -e 'add mod3 = Super_R' On my Sun Ultra 10 with Sun 5c keyboard I use respectively the right & left keys marked with a diamond: xmodmap \ -e 'keycode 115 = Super_L' \ -e 'keycode 116 = Super_R' \ -e 'add mod3 = Super_R' \ -e 'add mod4 = Super_L' If you don't use fvwm then, instead of the last step, look at the output of 'mk.xchar fvwm' & create similar key mappings for your window manager, and send them to me so I can add them to mk.xchar. Maybe some xmodmaps will be needed as well. Brian Keck bwkeck@gmail.com $Source: /home/keck2/xwin/taskbar/makemaker/RCS/README,v $ $Revision: 1.3 $$Date: 2007/07/07 13:13:27 $ xchar version 0.2